Elixir Cyclic Dependencies

When to Use

Apply this skill only when the user explicitly asks to check or remove cyclic dependencies (e.g. "check for cycles", "remove cyclic dependencies", "fix xref cycles").

Prerequisite: Elixir Version

Cycle detection is correct only on Elixir 1.19 or higher. Before running any cycle checks:

1. Verify version: elixir -v or inside the project run mix run -e 'IO.inspect(System.version())'.
2. If the version is below 1.19, stop and inform the user that upgrading to Elixir 1.19+ is required for reliable cycle detection.

Detecting Cycles

Run both commands from the project root. Start with a relaxed threshold, then tighten:

mix xref graph --format cycles --label compile-connected --fail-above 3
mix xref graph --format cycles --label compile --fail-above 3

• compile-connected: cycles in the compile-time dependency graph (modules that compile in a cycle).
• compile: same graph, different label; both should be run.
• --fail-above N: exit code fails when cycle count is above N. Use 3 initially, goal is 0.

To list cycles without failing (for inspection), omit --fail-above or set it high:

mix xref graph --format cycles --label compile-connected
mix xref graph --format cycles --label compile

Goal: reach --fail-above 0 for both commands (no cycles).

Workflow

1. Check Elixir version (must be ≥ 1.19).
2. Establish baseline: run both xref commands with --fail-above 3 (or current project setting). Note cycle count and which modules appear in cycles.
3. Inspect cycles: run without --fail-above to see full cycle output; identify the smallest set of edges (module A → module B) that, if removed, break cycles.
4. Plan minimal changeset:
   • Prefer breaking a single dependency (e.g. move shared code to a new module both can depend on) over large refactors.
   • Helper modules are allowed if they yield the smallest change: extract shared logic into a new module that the cycle participants depend on, so the cycle is broken.
   • Avoid duplication; follow existing repository guidelines (e.g. AGENTS.md, .cursor rules) and prior patterns in the codebase.
5. Implement: make the chosen change, then re-run both xref commands with --fail-above 0 (or gradually lower from 3 → 0).
6. Verify: mix compile --warnings-as-errors, tests, and any project lint (e.g. mix lint or mix cyclecheck if defined).

Minimal-Change Strategies

Choose the option that removes cycles with the least code churn and no new duplication.

Project Integration

If the project has a cyclecheck (or similar) task in mix.exs, use it after changes:

mix cyclecheck

Ensure it runs both xref commands with the target --fail-above 0 once cycles are cleared.

Summary Checklist

• Elixir version ≥ 1.19 confirmed
• Both compile-connected and compile xref cycle commands run
• Goal: --fail-above 0 for both
• Minimal changeset (helper modules OK)
• No code duplication; follows repo guidelines
• mix compile, tests, and lint pass after changes